Warning
•
Remember to tighten all the four corner screws to fix the loudspeaker seal after
electric installation to avoid water in-leak! A PZ1 cross-head screwdriver is
recommended.
14. Take out the name plates from the plastic cover. Use a flat-bladed screwdriver, for
example.
15. Remove the inserts from the name plates.
16. Insert the printed foil labels.
17. Put the inserts back in the name plates.
18. Replace the name plates, clicking them into position. The name plates hold the matt foil
inserted underneath.
Installation manual 2N® IP Vario
46 / 113