Table of Contents
Advertisement
1.
The terminal block is included in the package. To adjust an already installed
®
2N
IP Vario, disconnect it IP from the power supply. Then pull to remove the terminal
block from the printed circuit board.
2.
Insert the wires under the respective terminals.
3.
Tighten the terminals using a flat screwdriver.
4.
Replace the terminal block to the printed circuit board.
Caution
•
Make sure that the cables leading through the 2N
are installed properly. For the correct installation of the cables refer to Figure 2.7.
Induction loop connection
The JST SHR-02V-S connector type is required to connect the induction loop output.
Ethernet Connection
For the connections and meanings of the wires see the table below. Join UTP cable wires 4
(blue) and 5 (white-blue) and attach them under terminal 6 on 2N
Join wires 7 and 8 and place them under terminal 5 of 2N
Terminal Block Connections
Installation manual 2N® IP Vario
®
IP Vario cover bottom groove
®
IP Vario in the same way.
®
IP Vario.
55 / 113
Advertisement
Table of Contents
