Table of Contents
Advertisement
Resetting procedure (version 535v5 and earlier)
®
1.
Switch 2N
IP Vario off.
2.
Connect the jumper into the resetting (default setting) position (put the display switch
into the F_RES position in the display-equipped models with 535v1 and 535v2 board
versions).
®
3.
Switch 2N
IP Vario on and wait for the acoustic start signal.
®
4.
Switch 2N
IP Vario off.
5.
Remove the jumper from the resetting (default setting) position (put the display switch
into the NORMAL position in the display-equipped models with 535v1 and 535v2 board
versions).
®
6.
Switch 2N
IP Vario on.
Configuration Jumpers on Display Connector
Installation manual 2N® IP Vario
59 / 113
Advertisement
Table of Contents
