Table of Contents
Advertisement
Status signalling:
Green LED
blinking
on
blinking
on
Configuration:
•
Connect the 2N
to the Configuration manual for 2N IP intercoms. Make sure that one LED at least on
®
the 2N
Security Relay is on or blinking.
•
Press and hold the 2N
programming mode (both the red and green LEDs are blinking).
•
Activate the intercom switch using the keypad, telephone, etc. The first code sent from
the intercom will be stored in the memory and considered valid. After code initialisation,
®
the 2N
IP Security Relay will pass into the operational mode (the green LED is blinking).
Caution
•
In case of resetting the factory default settings on a device with a version of
firmware 2.18 or higher it is necessary to reprogram the
®
2N
Security Relay using the instructions above.
Red LED
off
off
blinking
blinking
®
Security Relay to the properly set intercom switch output; refer
®
Security Relay Reset button for 5 seconds to put the device in the
Installation manual 2N® IP Vario
Status
Operational mode
Activated output
Programming mode – waiting for
initialisation
Error – wrong code received
82 / 113
Advertisement
Table of Contents
