2N IP Vario Installation Manual page 45

9. Connect the cables as described in subsection 2.4, Mounting – Electrical Installation.
Make sure that the cables are not squeezed while installing the plastic cover. For the correct
cable installation.
10.Remove the protective foil from the display (for display-equipped 2N
only).
11. Make sure that the cables are placed properly inside and that none of them obstructs a
perfect cover closure.
12. Make sure that the three loudspeaker holder feet fit into the board holes. Keep the
required loudspeaker position to make the seal work properly.
13.Having mounted the unit on the wall and connected all cables, replace the plastic cover
using cross-recessed screws.
Installation manual 2N® IP Vario
®
IP Vario versions
45 / 113