Table of Contents
Advertisement
Warning
•
Never remove the main board or camera electronics from under the lower cover
while installing 2N
main board. Do not bend and press upon the flat cable either.
4. In multiple-module assemblies connect the boxes, placing the basic module to the left
and the extending modules to the right. The interconnecting cable shall be connected later!
5. Install blank modules on the unused side holes as shown in Figure previous step.
6. If you are installing a roof module, put it on the wall now.
®
7. Fix 2N
IP Vario on the wall with screws. Carry the supply cables (Ethernet, lock, power
cables) to the basic module box through one of the holes. Seal the screw hole carefully with
some cement or non-aggressive silicone to avoid water infiltration.
Warning
•
Make sure that the mounting surface for the 2N
perfectly flat. Avoid mechanical overload upon the bottom part of the cover. An
incorrect installation on an uneven surface may lead to cover deformation and
thus product malfunctions.
8. While installing a roof module, paste its top and side edges to the wall using silicone glue
to prevent water from flowing into the box along or around the cables.
®
IP Vario. Do not disconnect the camera flat cable from the
Installation manual 2N® IP Vario
®
IP Vario door communicator is
44 / 113
Advertisement
Table of Contents
