Table of Contents
Advertisement
Note
•
The delay after pressing RESET till the first light and sound signalling is set to 15–
35 s depending on the 2N IP intercom/answering unit model used.
•
24 s is the valid value for 2N
Static IP Address Setting
Follow the instructions below to switch on the Static IP address mode (DHCP OFF):
•
Press and hold the RESET button.
•
Wait until the red and green LEDs go on simultaneously on the device and the acoustic
signal
can be heard (approx. 15–35 s).
•
Wait until the red LED goes off and the acoustic signal
another 3 s).
•
Release the RESET button.
The following network parameters will be set after restart:
•
IP address: 192.168.1.100
•
Network mask: 255.255.255.0
•
Default gateway: 192.168.1.1
Installation manual 2N® IP Vario
®
IP Vario HW version 8.
can be heard (approx. for
61 / 113
Advertisement
Table of Contents
