Static IP Address Setting
Follow the instructions below to enable the static IP address mode:
®
•
Connect 2N
IP Vario to the power supply (or, disconnect and reconnect it if already
connected).
•
Wait for the first acoustic signal
•
Press following buttons sequentially:
•
1, 1, 1, 2, 2, 3 for 3-buttons models
Switching to static IP address
•
4, 4, 4, 5, 5, 6 for 6-buttons models
•
The acoustic signal
•
Wait until the device is restarted automatically.
Note
•
The 1, 1, 1, 2, 2, 3 sequence must be entered within 30 seconds after the first sound
signal for security reasons. The inter-digit delay may be 2 s at most.
The device will have the following network parameters after restart:
•
IP address – 192.168.1.100
•
Network mask – 255.255.255.0
•
Default gateway – 192.168.1.1
.
indicates mode switching.
Installation manual 2N® IP Vario
91 / 113