Configuring The Dicom Gateway - AGFA Auto QC2 User Manual

86 | Auto QC² | Main Menu

Configuring the DICOM Gateway

In the Main Menu window of Auto QC² Software the user or service engineer
can configure the DICOM gateway.
To configure the DICOM gateway:
1. In the Configuration panel in the top section of the Main Menu window,
select the DICOM Gateway label.
The workspace of the Main Menu window is filled with the configuration
fields for the DICOM Gateway:
Figure 67: Main Menu window with configuration fields for DICOM
gateway.
2. Set or modify the following parameters:
• DICOM AE-Title.
• Port Number.
• Maximum time-out for the DICOM association in seconds.
3. Click Save to save the new parameters, otherwise click Close.
2370C EN 20180330 1524