AGFA Auto QC2 User Manual page 64

64 | Auto QC² | General Workflow
Figure 43: View window with Zoom action buttons highlighted.
You have the choice between 3 zoom factors (factor 1, 2 and 4). In the
zoom area, the part of the image will be shown in "enhanced viewing"
mode.
When you change the Zoom factor:
• The image will be shown with the specified zoom factor.
• The scale indicator on the image is recalculated.
• The square marker around the selected location in the image will be
Accepting or Rejecting Images
These action buttons must be used when a visual check is necessary. If this
check is needed to perform a test correctly, the buttons will be available. If this
check is not necessary, they will be disabled.
The criteria to pass an image or reject an image depend on the test performed.
Refer to the separate Auto QC² Workflow Sheets (2374 A).
To pass an image:
Click the Pass action button.
2370C EN 20180330 1524
resized.