Table of Contents
Advertisement
68 | Auto QC² | General Workflow
Figure 49: The Procedure Results window.
In the above window a result is generated for the Periodic Quality Control.
In the Test overview all tests are summarized belonging to this Test Group
of the Periodic Quality Control.
Refer to the Workflow Sheets for more information.
2. Use the action buttons to switch between the different tests.
3. Analyze and interpret the results.
Refer to the separate Auto QC² Workflow Sheets (2374 A).
4. The symbol in front of the test shows if the test result is failed or passed for
the different tests. It can also give an indication that the results could not
be calculated. If this occurs, exposures need to be redone.
2370C EN 20180330 1524
Note:
If one or more of the images cannot be used for the calculation,
the execution of the algorithm will fail and an error message
will be shown. Check the images, delete them and retake them if
necessary. As long as something is wrong, the same error
message will appear when you press the Generate Results action
button.
Advertisement
Table of Contents
