1. Manuals
  2. Brands
  3. Xilinx Manuals
  4. Motherboard
  5. Virtex-6 FPGA
  6. Getting started

Running The Petalinux Demo - Xilinx Virtex-6 FPGA ML605 Embedded Kit Getting Started

Hide thumbs Also See for Virtex-6 FPGA ML605 Embedded Kit:
Table of Contents

Advertisement

Introduction
7.
Note:
for the Video demo.
Now you are ready to run the PetaLinux pre-built demo provided with this kit. Follow the
next set of instructions to run the demo.

Running the PetaLinux Demo

8.
X-Ref Target - Figure 6
9.
X-Ref Target - Figure 7
Note:
boot image for the 12.1 release.
10. Login with user name as root and password as root.
18
Open and configure a serial communications terminal utility program with the
following settings:
•
Baud Rate: 115200
•
Data: 8 bit
•
Parity: None
•
Stop: 1 bit
•
Flow Control: None
Note: The baud rate (115200) for the PetaLinux demo is not the same baud rate (9600) used
Press the SYSACE Reset button (SW3).
Figure 6: ML605 SYSACE RESET Button
After ~20 seconds, the PetaLinux boot output should be displayed on the serial
communications window as shown in
Figure 7: PetaLinux UART Output
The PetaLinux boot image shown in
www.xilinx.com
UG730_24_111309
Figure
7.
Figure 7
refers to version 11.4. However, this is the valid
ML605 Getting Started Guide
UG730 (v1.1) June 14, 2010
UG730_06_111309

Advertisement

Table of Contents
loading

Related Manuals for Xilinx Virtex-6 FPGA ML605 Embedded Kit

Related Content for Xilinx Virtex-6 FPGA ML605 Embedded Kit

Table of Contents