Testing The Usb-Uart Driver Installation - Xilinx Virtex-6 FPGA ML605 Embedded Kit Getting Started

Installation and Licensing of ISE Design Suite 12.1
X-Ref Target - Figure 24
8.

Testing the USB-UART Driver Installation

9.
10. Set the SACE MODE DIP switches (S1) as shown in
11. Press the SYS ACE RESET button (SW3) shown in
X-Ref Target - Figure 25
30
Figure 24: Setting the COM port for the Silicon Labs USB to UART Bridge Driver
Click OK to exit all open windows.
Start a serial communication program like HyperTerminal or TeraTerm on the Host PC
with the following settings:
• Baud Rate: 9600
• Data Bits: 8
• Parity: None
• Stop Bits: 1
• Flow Control: None
Demo. Make sure the CompactFlash (CF) card is still inserted.
Figure 25: ML605 SYSACE RESET Button
www.xilinx.com
UG730_23_111309
Figure 3 and listed in Table
Figure 25 to re-load the Video
UG730_24_111309
ML605 Getting Started Guide
UG730 (v1.1) June 14, 2010
2.