Petalinux Demo Hardware Setup Instructions - Xilinx Virtex-6 FPGA ML605 Embedded Kit Getting Started

Introduction
X-Ref Target - Figure 5
EEPROM
Note:
Embedded Kit MicroBlaze Processor Subsystem Data

PetaLinux Demo Hardware Setup Instructions

1.
2.
Table 5: ML605 Jumper Settings
Jumper REFDES
16
Memory
FLASH/SRAM
FLASH
Controller
(32 MB
SysACE
Compact
CompactFlash
FLASH
Controller
IIC EEPROM
Controller
Multiport
DDR3
Memory
(512 MB)
Controller
User Access to
External Memory
User Access to
Internal Memory
Figure 5: Virtex-6 FPGA PetaLinux System
Details about the system used for the PetaLinux demo can be found in
Install the USB-UART driver to your host computer by executing the steps specified in
the Communicating with the ML605 USB-UART
Confirm that the ML605 jumper settings are at default, as shown in
J66
J67
J68 J66 pins 1-2, J68 ON: RGMII, modified MII in Cu
J18
J17
www.xilinx.com
MicroBlaze Processor Subsystem
Processor Block
Internal RAM
(8 KB)
MicroBlaze
8 KB I and D Caches
Dual
Timer/Counter
Internal
Interrupt
RAM
Controller
(64 KB)
User Interrupts
Configurable User Logic
Sheet.
Function
GMII
pins 1-2: GMII/MII to Cu
pins 2-3: SGMII to Cu, no clk
pins 1-2: GMII/MII to Cu
pins 2-3: SGMII to Cu, no clk
FMC JTAG Bypass
Exclude FMC LPC connector
Exclude FMC HPC connector
Input/Output
GPIO
GPIO Positional LEDs
GPIO
GPIO
UART
Line Driver/
16550
TriMode
Ethernet
MAC
XC6VLX240T
DS758 ML605
section.
Table 5.
Default
Jump 1-2
Jump 1-2
No Jumper
Jump 1-2
Jump 1-2
ML605 Getting Started Guide
UG730 (v1.1) June 14, 2010
LEDs
Buttons
Switches
RS232
Receiver
Ethernet
PHY
UG730_05_051210