Using Petalinux 2016.X To Build Linux Image For Zcu102 - Xilinx ZCU102 Getting Started Quick Manual

Using Petalinux 2016.X to build Linux Image for ZCU102

In the last section we used the OSL flow to create the Linux image. Here, we shall be using the
Petalinux 2016.X to create the image.
Note: It is assumed that the user has pre-installed the Petalinux tools. There is an installer at the
here. Users can use the ZCU102 BSP to create the linux, Image, or they can use the HDF to config the
image. Both flows are discussed here.
First download the ZCU102 BSP from Xilinx.com here, and use the instructions below to build the
Petalinux project:

petalinux-create -t project -s Xilinx-ZCU102-v2016.X-final.bsp
o Where X is either 1 or 2

cd Xilinx-ZCU102-2016.1

cp -r pre-built/linux/images/* images/linux/
o Note: you can also just use petalinux-build here.
More Info: See the Petalinux guide
Users can also use a HDF file from the previous section to build the Linux Image (and SD boot
images):

petalinux-create --type project --template zynqMP --name petalinux_2016

petalinux-config --get-hw-description=<path/to/folder/containing/HDF> -p petalinux_2016
o Save, and Exit

cd petalinux_2016

Open the subsystem/linux/configs/device-tree.dts file and add the content below:
&gem3 {
status = "okay";
local-mac-address = [00 0a 35 00 02 90];
phy-mode = "rgmii-id";
phy-handle = <&phy0>;
phy0: phy@c {
};
};

petalinux_build

petalinux-package --boot --fsbl images/linux/zynq_fsbl.elf --fpga
images/linux/design_1_wrapper.bit --uboot
o This will create the two files needed on the SD card:


here for more info.
reg = <0xc>;
ti,rx-internal-delay = <0x8>;
ti,tx-internal-delay = <0xa>;
ti,fifo-depth = <0x1>;
BOOT.BIN
/images/linux/image.ub
© Copyright 2016 Xilinx
link