Xilinx Virtex-6 FPGA ML605 Embedded Kit Getting Started page 14

Introduction
3.
4.
X-Ref Target - Figure 4
Table 4: Video Demo Web Page Selections
14
Open a web browser on the host computer and set the URL to 192.168.1.10.
You should see the web page shown in
page and the operation performed are described in
Figure 4: Video Demo Web Page
Selection
Either select one of the images shown or browse to an
uncompressed 24BPP Windows bitmap image in the
Image Selection ML605_Embedded_Kit\Test_Images directory. This image is sent
to the MicroBlaze Processor Subsystem and displayed. FIR filters
are applied to the image.
Identity Output image is unmodified.
Areas of high contrast are detected and shown in white; the
Edge Detect
remainder of the image is black.
Smooth A slight blurring effect is applied to the output image.
Sharpen Contrast is increased in the output image.
Manually entered coefficients are sent to the MicroBlaze Processor
User
Subsystem and applied to the output image.
The MicroBlaze Processor Subsystem continuously cycles from
Auto
Identity to Edge Detect effects until a new selection is chosen.
Gain Slider controls the output image gain (0.0 - 1.0).
www.xilinx.com
Figure 4. The various selections in the Web
Table 4.
UG730_04_111309
Operation
ML605 Getting Started Guide
UG730 (v1.1) June 14, 2010