Table of Contents
Advertisement
Configuration
4.1
Note: Where switches are referenced in this chapter, "SWX" refers to the switch number and "-N" refers
Table 3.
®
Intel
NetStructure
Downloaded from
Elcodis.com
electronic components distributor
The ZT 5515 has been designed for maximum flexibility. Many features can be configured by the
user for specific applications. Most configuration options are selected through the BIOS Setup
utility (discussed in
Section 3.7, "BIOS Configuration Overview" on page
cannot be software controlled and are configured with switches. Switch options are made by
closing or opening the appropriate switch.
Switch Options and Locations
The ZT 5515 contains a push-button switch on the faceplate and three banks of DIP switches on the
component side of the board. The switches are listed and briefly described in the "Switch Cross-
Reference" table below.
Factory default switch settings are shown in
to the switch segment (SW4-2 means "switch number 4, segment 2").
Switch Cross-Reference Table
Switch
SW1
Reset (push-button on faceplate)
SW2-1
BIOS flash write protect
SW2-2
Baseboard Management Controller write protect
SW2-3
Real Time Clock reset
SW2-4
CMOS Clear
SW3-1
BIOS Recovery Module/Flash Select
SW3-2
Bypass BMC to power up
SW3-3
Ethernet SMBUS Isolation
SW3-4
VGA routing (front / back)
SW4-1
User Software Configuration 0
SW4-2
User Software Configuration 1
SW4-3
Console Redirection
SW4-4
BMC dual domain mode
SW5
Ejector
TM
ZT 5515 Compute Processor Board Technical Product Specification
Figure 6, "Default Switch Configuration" on page
Function
Configuration
4
26). Some options
30.
29
Advertisement
Table of Contents
