Section 3: Installation
May 2013
3.4.6
Power module installation
Figure 3-7. Power Module Installation
To make connections, perform the following procedure:
Note
This transmitter uses the Black Power Module. Please order model number 701PBKKF or spare
part number 00753-9200-0001.
1.
2.
3.
3.4.7
Installing the LCD display
Transmitters ordered with the LCD display will be shipped with the display installed.
Note
Only use Rosemount Wireless LCD Part Number: 00753-9004-0002
Note
An LCD from a wired device will not function in a wireless device.
In addition to housing rotation, the optional LCD display can be rotated in 90-degree increments
by squeezing the two tabs, pulling out, rotating and snapping back into place.
If LCD pins are inadvertently removed from the interface board, carefully re-insert the pins
before snapping the LCD display back into place.
40
Wireless Power Module Installation
Remove the housing cover on the Power Module compartment side. The Power Module
supplies all power to the transmitter. Plug and seal both conduit connections on the
transmitter housing to avoid moisture accumulation in the terminal side.
Connect the Power Module.
Replace the Power Module cover and tighten to safety specification (metal to metal).
Reference Manual
00809-0200-4802, Rev BA
Installation