Table of Contents
Advertisement
Reference Manual
00809-0200-4802, Rev BA
6.4.3
Reassemble the process flange
1.
Note
If you are replacing the o-rings, be careful not to scratch the o-ring grooves or the surface of the
isolating diaphragm when removing the damaged o-rings.
2.
3.
a.
b. If the installation requires a
c.
d. Hold the flange adapters and adapter o-rings in place while finger-tightening the bolts.
e. Align the process flange with the manifold.
f.
g. Tighten the bolts to the initial torque value using a crossed pattern. See
h. Tighten the bolts to the final torque value using a crossed pattern. See
i.
Troubleshooting
Inspect the Teflon SuperModule o-rings. If the o-rings are not damaged, reuse them.
Replace o-rings that show any signs of damage, such as nicks, cuts, or general wear.
Install the process flange on the SuperModule. To hold the process flange in place,
install the two alignment screws to finger tight (screws are not pressure retaining). Do
not overtighten; this will affect module-to-flange alignment.
Install the appropriate flange bolts.
If the installation requires a
Step f.
flange/adapter bolts. For gage pressure configurations, use two 2.88-in. bolts and two
1.75-in. bolts. Go to Step d.
If the installation uses a manifold (differential pressure applications only), use
appropriate bolts. Go to Step e.
Go to Step g.
Finger tighten the bolts.
appropriate torque values.
appropriate torque values. When fully tightened, the bolts should extend through the
top of the module housing.
If the installation uses a manifold, then install flange adapters on the process end of the
manifold using the 1.75-in. flange bolts supplied with the transmitter.
/
–18 NPT mounting, use four 1.75-in. flange bolts. Go to
1
4
/
–14 NPT mounting, use four 2.88-in. process
1
2
Section 6: Troubleshooting
May 2013
Table 6-4
for
Table 6-4
for
75
Advertisement
Table of Contents
