Section 2: Configuration
May 2013
2.6
Review configuration data
The following is a list of factory default configurations that can be viewed by using the Field
Communicator or AMS. Follow the steps below to review the transmitter configuration
information.
Note
Information and procedures in this section that make use of Field Communicator fast key
sequences and AMS assume that the transmitter and communication equipment are
connected, powered, and operating correctly.
2.6.1
Review Pressure Information
Fast Keys
To view pressure information:
1.
2.
3.
4.
1
2
3
4
5
10
2, 2, 2
From the Home screen, choose 2: Configure.
Choose 2: Manual Setup.
Choose 2: Pressure.
Choose from the corresponding number to view each field:
Pressure
Pressure Status
Units
Damping
Sensor Limits
Reference Manual
00809-0200-4802, Rev BA
Configuration