Setting Up The Reader; Configuring The Bc6020 Base Station - Datalogic RIDA DBT6400 Quick Reference Manual

Setting Up the Reader

Setting Up the Reader
Follow the steps below to connect and get your reader up
and communicating with its Host.
1. Configure the Base Station (if available)
2. Charge the Batteries (see
page
3. Link to a Host (see
the Base Station (if available - see
Station on page
4. Select the Interface Type for Base Station (if avail-
able - see
25).
5. Configure the Reader (optional, depends on settings
needed).

Configuring the BC6020 Base Station

Place the RIDA scanner on the Base Station as shown in
the figure below.
The Base Station can be powered up by an external power
supply or by a Host via the micro USB Cable. Both the
power cable and the micro USB cable can be connected at
the same time on the Base; in this case, USB connection is
used for data exchange with the Host, while power is sup-
plied from external power supply.
The figure below shows how to connect the Base Station
to a terminal PC or to another Host device.
4
6).
11).
Selecting the Base Interface Type on page
Charging the Batteries on
Linking to a Host on page 8) or to
Linking to a Base
RIDA™ DBT6400