Datalogic Gryphon I GM440 Series Product Reference Manual page 305

STAR Radio Protocol Timeout
This parameter sets the valid wait time before transmission between the
handheld reader and Base Station is considered failed.
When setting this parameter, take into consideration the radio traffic (num-
ber of readers in the same area). The selectable range for this feature is from
02 to 25 seconds.
Follow these instructions to set this feature:
1. Determine the desired setting.
2. Pad the number with leading zeroes to yield two digits. For example: 2
3. Go to
4. Scan the barcode: SELECT RADIO PROTOCOL TIMEOUT.
5. Scan the appropriate two digits from the keypad in
If you make a mistake before the last character, scan the CANCEL bar-
code to abort and not save the entry string. You can then start again
at the beginning.
6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Program-
This completes the procedure. See
set this feature.
Table 22. STAR Radio Protocol Timeout Examples
STEP ACTION
1 Desired Setting
2 Pad with leading zero(es)
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECTSTAR RADIO PROTOCOL TIMEOUT SETTING
Scan Two Characters From
5
Appendix D, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
Product Reference Guide
= 02, 5 = 05, 25 = 25, etc
page 259 and scanScan the ENTER/EXIT PROGRAMMING MODE
barcode to enter Programming Mode.
pad, that represent the duration which was determined in the steps
above. You will hear a two-beep indication after the last character.
ming Mode.
EXAMPLES
2 Seconds
02
'0' and '2'
Table 22 for some examples of how to
5 Seconds 10 Seconds
05 10
'0' and '5' '1' and '0'
RF Features
Appendix D, Key-
25 Seconds
25
'2' AND '5'
295