Enter/Exit Programming Mode
RS-485 Slave Minimum Address
Specifies the minimum address that can be set for a Cradle in an RS-485
network.
The maximum number of cradles in a single network is 16 (including the Master if
present). All cradles in the system must have different addresses.
$CR4JB
Slave Minimum Address
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
RS-485 Slave Maximum Address
Specifies the maximum address that can be set for a Cradle in an RS-485
network.
The maximum number of cradles in a single network is 16 (including the Master if
present). All cradles in the system must have different addresses.
$CR4JC
Slave Maximum Address
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
242
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left followed by four digits from the Alphanumeric
Appendix D, Keypad
characters in
your desired character(s). End by scanning the
ENTER/EXIT bar code again.
~
CANCEL
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left followed by four digits from the Alphanumeric
Appendix D, Keypad
characters in
your desired character(s). End by scanning the
ENTER/EXIT bar code again.
~
CANCEL
PowerScan™ PD953X/PBT950X/PM950X
representing
representing