Table of Contents
Advertisement
Qualified Personnel: The ITCS-100-H81 must be installed and operated only
by trained and qualified personnel. Maintenance, upgrades, or repairs may
only be carried out by qualified personnel who are familiar with the associated
dangers.
Air Circulation: Make sure there is sufficient air circulation when installing the
ITCS-100-H81. The ITCS-100-H81's cooling vents must not be obstructed by
any objects. Blocking the vents can cause overheating of the ITCS-100-H81.
Leave at least 5 cm of clearance around the ITCS-100-H81 to prevent
overheating.
Grounding: The ITCS-100-H81 should be properly grounded. The voltage
feeds must not be overloaded. Adjust the cabling and provide external
overcharge protection per the electrical values indicated on the label attached
to the back of the ITCS-100-H81.
3.3 Ha rd Dis k Drive (HDD) In s ta lla tio n
To install the hard drive, please follow the steps below:
S te p 1:
Remove the bottom panel by removing the ten retention screws from the bottom
panel (Figure 3-1).
Figure 3-1: Remove Retention Screws
S te p 2:
Remove the four HDD bracket retention screws. (Figure 3-2)
P a g e 14
ITCS -100-H81 Em b e d d e d S ys te m
Advertisement
Table of Contents
