Table of Contents
Advertisement
1. PARTS NAMES AND FUNCTIONS
1-1 FRONT PANEL
1)
7)
1) Indicator ........................................ • Displays a measured value, various selected functions, and set values.
2) Unit Label ..................................... • Select the desired unit from the accessory unit label sheet and attach it
3) [LOCK] LED ................................ • When this [LOCK] LED is lit or flickering, no functions are set.
4) [HIGH] Limit LED ....................... • Lights up when the measured value exceeds the high limit value.
5) [OK] LED ..................................... • Flickers when the measured value exceeds the low limit value or
6) [LOW] Limit LED ........................ • Lights up when the measured value is less than the low limit value.
7) Operation Key ................................ • A pushbutton switch to operate the WGI-400A.
8) Status Indicator ............................... • In the measuring state, pattern No. is displayed.
Note: The WGI-400A is not responding to the [HOLD] function.
5)
4)
• Normally, it is displayed with the measured value responding to the
output from transducers. However, if error occurs, error message
appears.
See "3-10 ERROR CODE TABLE."
on this portion.
Always turn OFF the [LOCK] LED before setting functions.
• However, high/low limit value is displayed even when the [LOCK]
LED lit.
• Flickers when the high limit value is displayed.
lowers the high limit value.
Flickers when the low limit value is displayed.
One key is used together for multiple functions that are automatically
switched according to measuring or setting states.
• During calibration, minimum-digit numeric value of rated output is
displayed.
6
6)
8)
2)
3)
Advertisement
Table of Contents
