1. PARTS NAMES AND FUNCTIONS
1-1 FRONT PANEL
1)
7)
1) Indicator .................................... • Displays measured value, various selected functions, and set values.
2) Unit Label .................................. • Select the desired unit from the accessory unit label sheet and attach it
3) [LOCK] LED ............................. • When this [LOCK] LED is lit or flickering, no functions are set. Always
4) [HIGH] Limit LED .................... • Lights up when the measured value exceeds the high limit value.
5) [OK] LED .................................. • Flickers when the measured value exceeds the low limit value or lowers
6) [LOW] Limit LED ..................... • Lights up when the measured value is less than the low limit value.
7) Operation Key ............................. • A pushbutton switch to operate the WGI-400A.
8) Status Indicator ............................ • In the measuring state, pattern No. is displayed.
5)
4)
• Normally, it is displayed with measured value according to the output
from transducers. However, if error occurs, error message appears.
on this portion.
turn OFF the [LOCK] LED before setting functions.
• However, high/low limit value is displayed even when the [LOCK] LED
lit.
• Flickers when the high limit value is displayed.
the high limit value.
Flickers when the low limit value is displayed.
One key is used together for multiple functions that are automatically
switched according to measuring or setting states.
• During calibration, minimum-digit numeric value of rated capacity is
displayed.
5
6)
8)
2)
3)