Parts And Functions; Front Panel - KYOWA DPM-900 Series Instruction Manual

2. PARTS AND FUNCTIONS

2-1 FRONT PANEL

１０
１１
1) TEDS switch
2) ACTL LOAD switch
3) L.P.F. switch
4) V ADJ. switch
5) H.P.F. switch
6) BAL switch
7) SET switch
8) CAL ON switch
9) KEY LOCK switch
10) VOLTAGE OUT switch
11) CAL switch
NOTE
Press and hold is an operation for continuously pressing the switch for 0.5 seconds or more.
Press twice is an operation to press the switch twice within 0.5 seconds.
３
１
４
２
Press and hold TEDS switch. The TEDS switch lights up in blue, the
setting mode becomes TEDS mode.
Press and hold ACTL LOAD switch. The ACTL LOAD switch lights up in
orange, the setting mode becomes setting mode with the input strain.
Changes a cutoff frequency of the low-pass filter.
< changes to a smaller one
> changes to a larger one
(10 Hz « 30 Hz « 100 Hz « 300 Hz « 1 kHz « FLAT)
Conduct zero-point fine adjustment and sensitivity fine adjustment of
output voltage.
+: Zero-point moves to a positive direction.
– : Zero-point moves to a negative direction.
With pressing the SET switch or + of the CAL ON switch, press + of the V
ADJ. switch for high sensitivity, press – for low sensitivity.
Press and hold H.P.F. switch to changes valid or invalid of the H.P.F.
When the H.P.F is valid, the H.P.F. lamp (item 19)) lights up.
Press the BAL switch twice for balancing.
Press and hold the BAL switch for disconnection check of the bridge.
Set the VOLTAGE OUT and CAL switches. Press the SET switch twice to
set the internal gain of the DPM-900/950 series.
+: Add + calibration signal that is set to the CAL switch to the output.
–: Add - calibration signal that is set to the CAL switch to the output.
Set the KEY LOCK switch to left for prohibiting operations other than
POWER switch.
For setting the output voltage.
For setting the input strain and required calibration signal value.
7
５
６
７
８
９