See the following figure for an illustration of a completed DIN installation
procedure.
3.
Grasp the bottom of the fieldbus gateway and slightly rotate it upwards. If there
is resistance, the fieldbus gateway is correctly installed. Otherwise, re-attempt
the installation process from the beginning.
2.3.1.2
Removing the DIN-Rail Mounting Kit
1.
Ensure that power is removed from the fieldbus gateway, and disconnect all
cables and connectors from the front panel of the fieldbus gateway.
2.
Push down on the top of the DIN rail clip release tab with your finger. As the clip
releases, lift the bottom of the fieldbus gateway, as shown in the following
illustration.
\
Figure 2.2 Correctly Installed DIN Rail Kit
Figure 2.3 Removing the DIN-Rail
17
EKI-1242 Series User Manual