Reset Button; Figure 2.21 Installing Dc Wires In A Terminal Block; Figure 2.22 Securing A Terminal Block To A Receptor - Advantech EKI-1242 Series User Manual

3. Insert a small flat-bladed screwdriver in the V1+/V1- wire-clamp screws, and
loosen the screws.
4. Insert the negative/positive DC wires into the V+/V- terminals of PW1. If setting
up power redundancy, connect PW2 in the same manner.
5. Tighten the wire-clamp screws to secure the DC wires in place.
6. Align the terminal block over the terminal block receptor on the fieldbus
gateway.
7. Insert the terminal block and press it in until it is flush with the terminal block
receptor.
8. Tighten the screws on the terminal block to secure it to the terminal block
receptor.
If there is no gap between the terminal block and the terminal receptor, the
terminal block is seated correctly.

Figure 2.22 Securing a Terminal Block to a Receptor

2.8

Reset Button

Reset configuration to factory default:
Press and hold the Reset button for 5 seconds.
System reboot:
Press and hold the Reset button for 2 seconds.
Note! Do NOT power off the fieldbus gateway when loading default settings.
Loosening
Wire-clamp
Screws
Installing
Wires

Figure 2.21 Installing DC Wires in a Terminal Block

DC
27 EKI-1242 Series User Manual
Securing
Wire-clamp
Screws