Fujitsu PA03768-B005 Operator's Manual page 264

Setting Item
Multifeed
Page Edge Filler (ADF)
Dropout color
Pre-Pick
Document check area specification for
Multifeed Detection
Intelligent Multifeed Function
Number of paper feeding retries
Cleaning Cycle
Life Counter Alarm Setting
Vertical Streak Detection
Vertical Streak Sensitivity
Pick Speed
AutoCrop Boundary
Manual Feeding
Power SW Control
Paper Protection
Paper Protection Sensitivity
Maintenance and Inspection Cycle
High Altitude Mode
Description
Configure the settings to detect overlapped documents during a
scan.
Configure the settings to fill in the shadow or streaks around
the edge of the scanned image.
You can exclude a color from being scanned by selecting either
red, green, or blue (three primary colors).
Enable this to shorten the scanning time when scanning
continuously.
Specify an area to detect overlapped documents.
Configure the setting to automatically ignore certain patterns of
overlapped documents when the setting to detect overlapped
documents is enabled.
Specify the number of feeding retries when a document is not
fed from the ADF paper chute (feeder).
Specify the cleaning cycle for the scanner inside.
Specify the replacement cycle for the consumables.
You can configure the settings for detecting dirt on the glass.
Specify the sensitivity level to detect vertical streaks (dirt on the
glass) when [Enable] is selected for [Vertical Streak Detection].
You can specify the timing of when document feeding is started.
When the scanner is set to detect the paper size automatically,
specify whether or not to optimize (round up/down) the
fractional part of the scanned image.
Configure the settings when manually loading and scanning
one sheet at a time.
Specify whether or not to turn on/off the scanner by pressing
the [Power] button on the scanner.
Configure the setting to detect feeding errors.
Specify the sensitivity level for detecting feeding errors when
the paper protection function is enabled.
Specify the maintenance and inspection cycle for the scanner
that is performed by a service engineer.
Enable this mode to use the scanner at an altitude of 2,000 m
or higher.
264
Scanner Settings (Software Operation Panel)