Daily Care; Cleaning Materials - Fujitsu PA03768-B005 Operator's Manual

Daily Care

This section describes how to clean the scanner.
● Do not use aerosol spray or spray that contains alcohol. Paper dust blown up by strong air
CAUTION
● The inside of the ADF becomes very hot when the scanner is being used.

Cleaning Materials

Name
Cleaner F1
Cleaning Paper
Cleaning Wipe
Cotton swab
Dry cloth
ATTENTION
In order to use the cleaning materials safely and correctly, read the precautions on each product thoroughly.
For more information about the cleaning materials, contact the distributor/dealer where you purchased this
product. Refer to the contact information in the Contact List if supplied with this product, or refer to the contact
from the spray may enter inside the scanner which may cause the scanner to fail or
malfunction.
Also note that sparks generated by static electricity may cause a fire.
Before you start cleaning the inside of the ADF, make sure to turn off the power, unplug
the power cable and wait for at least 15 minutes for the inside of the ADF to cool down.
Part No.
PA03950-0352
CA99501-0012
PA03950-0419
Commercially
available
Notes
100 ml
Liquid cleaner to use for removing dirt and stains
10 sheets
Used to clean the inside of the scanner with ease.
Spray it with Cleaner F1 and scan it with the scanner
in the same way as a document.
24 packets
Pre-moistened with Cleaner F1. It can be used instead
of moistening a cloth with Cleaner F1.
Used to clean a tiny part such as the ultrasonic sensor.
Used to wipe off dirt and stains. Moisten it with
Cleaner F1 for cleaning.
114