Table of Contents
Advertisement
Set Up Targets
Press
to exit the Run screen and show the Menu screen.
Select
and press
Press
or
to highlight required Target # (T01 –
T20).
Press
to enter Target Set Up / edit.
Press
to increase,
value.
TIP:
Keep button pressed for rapid rate of target
change.
When set press
to accept.
Press
to increase,
This is angle applied after torque is applied.
TIP:
Keep button pressed for rapid rate of angle target
change.
If in doubt leave as 0°
When set press
NOTE:
This screen will only be shown if the angle target
was set larger than '0°' on the Set Angle screen.
Press
to increase,
Target value.
When set press
to accept.
to view targets.
decrease the Torque Target
to decrease Angle Target value.
to accept.
decrease the Final Torque
FIGURE 22 – Select Target Set Up
FIGURE 23 – Select Target #
FIGURE 24 – Set Target Torque
FIGURE 25 – Set Target Angle
FIGURE 26 – Set Final Torque Target
17
Advertisement
Table of Contents
