SET UP INSTRUCTIONS
NOTE:
If the equipment is used in a manner not specified by the manufacturer, the protection
provided by the equipment may be impaired.
WARNING:
Please complete the set up in the order shown.
Top Handle
The tool is supplied with a top handle attached to the tool. For hand held use it is recommended to always
use the top handle as loss of tool control can cause personal injury. If a hangar (balancer) is required, attach
to top handle.
Should the top handle not be required it can be removed as follows:
1. Use 5mm hex key (supplied) to remove fixing bolts, see figure 3, then remove handle
2. Install two infills (supplied) then re-fit bolts; see figure 4.
The infills must be fitted to maintain the tool's environmental rating.
ALLOW THE TOOL TO EQUALISE TO THE AMBIENT TEMPERATURE /
HUMIDITY BEFORE SWITCHING ON. WIPE OFF ANY MOISTURE BEFORE
USE.
FIGURE 3 – Removal of Top Handle
FIGURE 4 – Install infills
9