Set Up Instructions; Pneutorque ® Hanger; Connecting Air Supply - norbar PNEUTORQUE PTM series Operator's Manual

SET UP INSTRUCTIONS

®
The Pneutorque set up covers the following items:
®
1. Pneutorque Hanger

2. Connecting Air Supply

3. Connecting Electric Supply
4. Air Lubrication
5. Torque Reaction
6. Clockwise / Counter-Clockwise
7. Setting Shut-Off Torque
Please complete the set up in the order shown.
®
Pneutorque Hanger
®
The Pneutorque hanger (Figure 1-E) is designed to be used with a suitable balancer to provided
comfortable tool use. Remove hanger if not required.
Connecting Air Supply
WARNING:
Make sure all hoses are clean, in good condition and free from dirt / water.
Connect the tool air inlet hose (Figure 1-C) to the outlet side of the lubro control unit (Figure 1-B) (not
supplied), observing air flow direction arrows.
TIP: On tools supplied with quick air couplings, fit the coupling plug
to the tool inlet and the coupling socket to air hose.
To connect, push couplings together.
To disconnect, pull back lock on socket coupling.
Connect the inlet side of the lubro control unit (Figure 1-B) to the air supply (Figure 1-A) using a minimum hose
size of 1/2" bore (12mm). Avoid using 1/2" bore hoses of longer than 5 meters from the supply to the pressure
regulator unit as this will reduce the performance of the tool.
Turn on air supply and check for air leaks.
TO AVOID HAZARD FROM WHIPPING AIR HOSES MAKE ALL
CONNECTIONS TO THE TOOL BEFORE TURNING ON THE AIR SUPPLY.
A
E
C
B
FIGURE 1 – Connections
D
F
G
7