Table of Contents
Advertisement
Gearbox
Under normal operating conditions it is not necessary to re-grease the gearbox. The gearbox contains Lubcon
Turmogrease Li 802 EP.
Drive Square
If the tool output drive is subject to torque overload there is potential for catastrophic tool damage. To reduce
this risk the output drive square has been designed, like a fuse, so it will shear first. The output drive square is
easy and quick to replace, for part numbers see ACCESSORIES listed in the INTRODUCTION. The drive
square is NOT covered by the standard product warranty.
To replace the drive square:
1.
Unplug tool from mains supply.
2.
Support tool in a horizontal position
3.
Use 4mm hex key (supplied) to remove the screw and then remove drive square.
If the square has sheared it may be necessary to use pliers to remove the broken parts.
4.
Fit new drive square.
5.
Fit new screw. Tighten to 9 N·m (M5).
TIP:
If the drive square fails continually then seek advice from Norbar or a Norbar distributor.
Product Disposal
28
FIGURE 56 – Drive Square Replacement
This symbol on the product indicates that it must not be disposed of in the
general waste.
Please dispose of according to your local recycling laws and regulations.
Contact your distributor or see the Norbar website (www.norbar.com) for further
recycling information.
Advertisement
Table of Contents
