Set Up Instructions; Battery - norbar EvoTorque EBT Series Operator's Manual

SET UP INSTRUCTIONS

NOTE: If the equipment is used in a manner not specified by the manufacturer, the protection
provided by the equipment may be impaired.
WARNING:
Please complete the set up in the order shown.

Battery

Only use EvoTorque ®
Insert battery into tool handle until latch operates.
1.
2. To remove battery press both side latch buttons and slide battery out.
It is recommended to remove the battery pack during tool set up.
Charge battery in separate EvoTorque
12
ALLOW THE TOOL TO EQUALISE TO THE AMBIENT TEMPERATURE /
HUMIDITY BEFORE SWITCHING ON. WIPE OFF ANY MOISTURE BEFORE
USE.
Battery Pack (EBP) battery with this tool.
FIGURE 3 – Insert & remove battery
® Battery Charger (CTC123 (60335)).
FIGURE 4 – Insert battery into charger