Table of Contents
Advertisement
Turn On
Turn on mains supply. Change ON/OFF switch from 0 to I.
The logo is shown for 2 seconds:
The capacity is shown for 2 seconds:
TIP:
Fan operation: During the logo & capacity
screens the fan will run to give confirmation that
it is working.
The target screen is shown:
The Target and direction are remembered from the last use.
Set Direction
Press
to set direction. This cannot be done when the
tool is running.
The tool is now ready to use. Press trigger and the following
screen will be shown.
TIP:
The tool operation is dependant on the Target Set
Up i.e. Torque, Torque & Angle or Torque Audit.
16
FIGURE 17 – Norbar Logo
FIGURE 18 – Tool Capacity,
Operational Voltage, Time & Date
FIGURE 19 – Torque & Angle Target
FIGURE 20 – Set Direction
FIGURE 21 – Run screen
Advertisement
Table of Contents
