Tool Settings - norbar ET2-72-1000-110 Operator's Manual

Tool Settings

This menu is used to set or view the Unit, Auto Reset, Lock, Bluetooth
Output Format, 2 Stage Target and Operation Direction.
FIGURE 31 – Tool Settings Menu
The Lock screen will appear if 'Lock' has been set.
FIGURE 32 – Unlock Tool
Enter PIN code to unlock using the
Confirm each number by pressing the
Menu Option
Unit
Auto Reset
Lock
®
Bluetooth
Time & Date
Display
Tolerances
Output Format
2 Stage Target
Operation /
or
button.
Details
Select N·m, lbf·ft, ft·lb or kgf·m.
✓=Enabled (Hold time 2 -10 seconds) / ✘= disabled (Manual Reset).
Lock Level
Off= Disabled.
1 = Enabled (No access to Tool settings, Erase results. No Target adjustment)
2 = Enabled (No exit from Run screen, no multiple Target selection)
(default Unlock PIN = 5000).The PIN can be set anywhere in the range 0000
to 9999
TIP: Keep a note of the pin code in a safe place
✓= Enabled (Bluetooth
hh:mm:ss dd – mm - yy
✓= Inverse Enabled / ✘ = Inverse disabled.
Torque 3% default (range 3 – 20), Angle 2º default (range 2 – 20), Turn Angle
0º default (disabled) range 0 – 99.
USER (CSV output for use outside of EvoLog) / EvoLog
✓= Enabled / ✘ = disabled (fast Snug followed by Angle Target).
,  or + Target Direction. If  or  is set, the Target for the opposite
direction is set at the Tool capacity (for undoing fasteners).
® , Time & Date, Display, Tolerances,
FIGURE 33 – Tool Set Up options 1
FIGURE 34 – Tool Set Up options 2
buttons.
®
Smart) / ✘ = disabled.
19