View / Select Work Group, Work Ids; View / Select Users - norbar ET2-72-1000-110 Operator's Manual

NOTE: This screen will only be shown if the angle
target was '0°' on the Set Angle screen.
Press or to enable '✓' or disable '✘'.
When set press to accept.
NOTE: This screen will only be shown if the Audit
mode? was
Press to increase/decrease the Tolerance value.
This is the expected / allowable angle the bolt can move on
by.
View / Select Work Groups & Work IDs
Press to View/Select the Work Group or any standalone
Work IDs on the tool. These can only be populated on the tool
via EvoLog, see EvoLog Operator's Manual part # 34427 for
more details.

View / Select Users

Press to View/Select any User IDs on the tool. These can
only be populated on the tool via EvoLog, see EvoLog
Operator's Manual part # 34427 for more details.
18
'✓'
on the previous screen.
FIGURE 27 – Set Audit Target
FIGURE 28 – Set Tolerance
FIGURE 29 – View / Select Work
Groups & Work ID's
FIGURE 30 – View / Select Users