Conning] Menu - Furuno FAR-3320-NXT Instruction Manual

1. INITIAL SETTING AND ADJUSTMENT
1.15

[Conning] Menu

The [Conning] menu configures the layout and data to show on the conning display.
Save / Import / Export
Decoder Define Import / Export
Decoder Import / Export
Menu item
Items on the menu bar
Conning (3x6)
Wide Conning (4x6)
Side Conning (1x9)
Mini Conning (1x5)
Save/Import/Export
Decoder Define Im-
port/Export
Decoder Import/Ex-
port
Items in the view area
Name
Show
Copy From
Components
1-54
Consists of 18 blocks (3x6). Six sets of conning layout sheet can
be prepared [Sheet 1] to [Sheet 6].
Consists of 24 blocks (4x6). Six sets of conning layout sheet can
be prepared [Sheet 1] to [Sheet 6].
Note: This setting is available when wide monitor is used.
Consists of 9 blocks (1x9). Four sets of conning layout sheet can
be prepared [Sheet 1] to [Sheet 4].
Note: The side conning display is available and can not be hid-
den with the wide monitor in the radar mode. The menu setting
in chart mode if the side conning is available or not available is
not active.
Consists of 5 blocks (1x5).
You can save the conning display data to a medium and load it
on the network.
No use.
No use.
Enter the name of the sheet displayed on the view area. The
sheet name entered here appears on the status bar of the con-
ning display.
Check the checkbox to show the sheet name on the status bar
of the conning display.
Copy a conning layout sheet to another sheet.
Select the components to show on the conning display. The
components are available in three sizes: [Small], [Medium],
[Large]. The [Small] components occupy one block. The [Medi-
um] components occupy two blocks. The [Large] components
occupy three or more blocks. Check the size of the component
to show on the [Components] window. Select the component
and click it to show the component on the [Layout] window.
Explanation