Furuno FAR-3320-NXT Instruction Manual page 26

1. INITIAL SETTING AND ADJUSTMENT
5, 6
7, 8
9, 10
11, 12
15, 16 or 14, 15
8. Check the checkbox of [Channel No.].
9. Set the items referring to the following table.
[Data Catego-
ry]
[+] button
[Equipment ID]
[Details]
1-20
Pin No. Direction
Output
Output
Output
Output
Input
Item
Sets the data category. Settings: [ALERT], [ACK], [BUZZER
STOP], [OPERATOR FITNESS], [OTHER], [GYRO SELEC-
TOR], [MOB].
This appears when the [Data Category] is set to [ALERT]. Click to
show the configuration of the alert input.
• [Equipment ID]: The Equipment ID is shown.
• [Alert ID]: The alert notification sentence* (ALF or ALR) and
alert number are shown. When the alert notification sentence
is ALF, the instance ID is shown.
*: According to the connected sensors.
• [ ] button: Opens the
[Alert No. Setting] win-
dow to select the input
alert. The following ex-
ample uses the alert noti-
fication sentence ALR.
Select the Equipment ID
for the connected sen-
sors from the [Equipment
ID] pull-down list. Then check the radio button of the desired
alert and click the [OK] button.
• [Alert Name]: The alert name is shown.
Select the Equipment ID from the pull-down list. This appears
when the [Data Category] is set to [ACK] or [BUZZER STOP].
The pull-down list options change according to the setting at
[Sensor Setting].
• [Name]: Enter the appropriate
sensor name.
• [Data Type]: Set the contact input
([Normally Open] or [Normally
Closed]).
• [Input Time (100msec)]: Set the
input time (recommended value:
5).
• [Dead Band (100msec)]: Set the
dead band after input (recom-
mended value: 50).
• [Calibration Active]: Keep the default setting. (Default: without
check)
• [Active Status (1)], [Active Status (0)]: Keep the default setting.
Channel No.
Channel 01 Normal Close
Channel 02 Normal Close
Channel 03 Normal Open
Channel 04 Normal Open
Channel 01 Depended on the configuration.
Remarks
Example: ALR is the alert notification sentence.
Contact Status
CRA001