Ccrs Setting] Window; Tcs] Menu - Furuno FAR-3320-NXT Instruction Manual

1.5.3

[CCRS Setting] window

Set if the NSR sentence is output from the CCRS in the [CCRS Setting] window of the
[CCRS] menu. This setting is currently unavailable. Confirm that the box has no check
mark.
1.6

[TCS] Menu

Select the data format for the route data created at this equipment on the [Other Set-
ting] window. The route data can be output to external equipment (GP-170 etc).
1. Access the [Common Installation Setting] menu, then select [TCS] from the tab
bar.
2. Select [Other Setting] from the menu bar.
Not used.
3. Set the options referring to the following table.
Menu item
[Output Route
Data Setting]
[Output Route File
Format]
[Source SFID]
4. To save the configuration, perform a consistency check, then save the configura-
tion data on the [Save and Sync] menu.
1. INITIAL SETTING AND ADJUSTMENT
Remove the checkmark.
Select the route data format.
• [File and RMB]: Output the route data with the file format
and RMB sentence. A LAN connection with the external
equipment is required.
• [RTE and WPL]: Output the route data with the RTE and
WPL sentences. A serial connection with the external
equipment is required.
Select whether the channel limit is symmetrical or asymmetri-
cal.
This setting is available when [Output Route Data Setting] is
set to [File and RMB].
• [Symmetrical]: The channel limit is symmetrical.
• [Asymmetrical]: The channel limit is asymmetrical.
Select the additional SFID when CCRS outputs the sentence
from the TCS ([ECDIS SFID] or [TCS SFID]).
Description
1-39