Table of Contents
Advertisement
3. To connect a VDR, select [Connected] at [Connection] in [VDR] then set each
items shown in the table below.
interactive field
[Monitor]
[Transmit per 15 sec.]
[Transmission Rate]
[Image Format]
[JPEG Quality]
[Network]
[Transmission Timing]
[Destination]
[Source]
[Location]
4. Click [Save] on the info bar. Several confirmation messages appear. Click [OK] to
reboot the system. To discard all changes, click [Discard Changes].
1.2.4
[Route Transfer] window
1. Access the [Common Installation Setting] menu and click [Basic Setting] on the
tab bar.
2. Click [Route Transfer] on the menu bar.
3. To transfer data to a specified network, select [Connected] from the [Connection]
pull-down list.
[Connection]
[Transmission Rate]
[Network]
[Destination]
[Initial Value of Sequence
No.]
4. Click [Save] on the info bar. Several confirmation mes-sages appear. Click [OK]
to reboot the system.
To discard all changes, click [Discard Changes].
Menu item/
Select the DVI port connected with the VDR.
Set the number of transmissions in 15 seconds.
Set the transmitting rate.
Set the image format.
Set the quality of JPEG data. Available when [JPEG] is se-
lected for [Image Format].
Select the network connected with the VDR.
Set the delay timing. The delay is applied regardless of the
Display Mode selected (RADAR or Back-up ECDIS).
Set the IP address and port of the destination.
Set the status and information text, max. 16 characters.
Set the status and information text, max. 32 characters.
Menu item
1. INITIAL SETTING AND ADJUSTMENT
Description
Description
Select [Connected] to transfer the data.
Set the transmission rate.
Select the destination network for route date.
Set the IP address and port of the destination.
Set the default value for the sequence identifier to be
used when transferring route data via LAN. This bina-
ry value is set in accordance with IEC 61162-450 reg-
ulations.
1-9
Advertisement
Table of Contents
