Installation Setting Examples - Furuno FAR-3320-NXT Instruction Manual

1.4.10

Installation setting examples

This section shows examples of initial settings made at the FAR-3000 and the result-
ing output to the AMS, BNWAS and ECDIS. Open [Installation Parameters] [Chart
Radar][No.1 Chart Radar][Serial Input/Output] to do the settings.
Serial Port setting
The table below shows examples of settings on the [Serial Input/Output] screen and
the resulting output.
Note: For LAN connection, do not set the serial port.
Serial Equipment
No.
Serial AIS001
01 (AI0001)
Serial GYO001
02 (HE0001)
Serial LOG001
03 (SD0001)
Serial GPS001
04 (GP0001)
Serial WAS001
05 (BN0001)
Serial OTR010
06 (OR0010)
Serial OTR011
07 (OR0011
Serial OTR001
08 (U10001)
Details-
ID Baud rate
38400 bps
38400 bps
4800 bps
4800 bps
4800 bps
38400 bps
4800 bps
4800 bps
WAS001 ( BN0001 ) ( No.1 BNW
OTR010 ( OR0010 ) ( No.1 ECDI
OTR011 ( OR0011 ) ( No.1 AMS
1. INITIAL SETTING AND ADJUSTMENT
Output Filter
For FAR-3000 initial settings, see
subsection 1.4.2.
EVE —
TTM, RSD, —
OSD
TTD, TTM*, —
TLB, RSD,
OSD
ALR ACK
ALF, ALC, ACN,
ARC, HBT HBT
For FAR-3000 initial settings, see
subsection 1.4.2.
Content (Objective)
For BNWAS output
For ECDIS output
(The ECDIS can receive
the TTM sentence.)
For ECDIS output
(The ECDIS can receive
the TTD, TLB sentence.)
*: Required for reference
target.
For AMS output
(The AMS can handle the
ALR/ACK sentence.)
For AMS output
(The AMS can handle the
ALF/ACN sentence.)
1-33