[Data Sharing] Menu; Save And Sync] Menu; Consistency Check And Save The Configuration - Furuno FAR-3320-NXT Instruction Manual

1. INITIAL SETTING AND ADJUSTMENT
2. Check the checkbox to delete the alert. If all alerts are deleted, check the "Select
all" checkbox.
3. Click the [OK] button.
4. To save the configuration, perform a consistency check, then save the configura-
tion data on the [Save and Sync] menu.
1.9

[Data Sharing] Menu

The [Data Sharing] menu has no use.
1.10

[Save and Sync] Menu

After completing the settings on the [Own Ship Setting], [Installation Parameters],
[CCRS], [AMS] and [Alert Define List] menus, confirm the consistency of the configu-
ration and save it on this menu. By saving the configuration, the configuration data can
be copied to other processor units connected to the network. The configuration data
can be saved to a medium and loaded to a processor unit.
1.10.1

Consistency check and save the configuration

1. Access the [Common Installation Setting] menu and click [Save and Sync] on the
tab bar.
2. Click [Consistency Check] to confirm the consistency of the setting.
When the consistency check is completed, the result of the check is shown.
If an inconsistency is detected, an error message appears. You can not save the
configuration until the inconsistency is corrected. Check the setting and correct
the inconsistency, then perform the consistency check again.
3. When the message "Check consistency com-
pleted, you can save data. Please push the
"Save" button" is shown, click [Save] in the
info bar.
The pop-up message shown right appears.
4. Click [OK] to save the configuration.
If other processor units and sensor adapters
are connected to the network, the confirma-
tion message shown below appears. The
message does not appear if a unit in the net-
work is not powered. Click [OK] to save the
configuration.
1-48