Furuno FAR-3320-NXT Instruction Manual page 59

Alert Define List Alert Define List Data Sharing Data Sharing
If "NG" appears, confirm the state of the unit on the [System Monitor] on the tab menu.
[Factory Default]
The factory default function restores all factory defaults (except the settings on the
[Basic Setting] menu). In the default arrangement all processor units powered in the
network are restored to default condition.To restore only the settings of the processor
unit, disconnect the LAN1 port of the processor unit from the network before restoring
the factory defaults.
Note: After restoring the factory default, the route settings and user chart data are re-
mained.
1. Click [Reset to Factory Default]. The following message appears on the screen.
2. Click [OK] to restore the system to the default setting.
The progress bar shows update progress. When the restoration is completed, the
system is automatically rebooted.
3. If connected to the gateway network, the link is shown on the display after com-
pleting the system reboot. Click the link on the display to access the [Common In-
stallation Setting] menu.
If connected to the sensor network, enter the IP address of the sensor network
to access the [Common Installation Setting] menu after completing the system re-
boot.
Note: When you restore the chart radar default, the initialization of the radar processor
unit needs more time than the processor unit. After completing the system reboot of
the processor unit, wait for about one minute until the system reboot is completed, and
the communication between processor unit and radar processor unit is established. If
the communication is not established, the alert "Radar Sensor COM Error" appears
and the [Antenna] button at the upper left of the display shows "NO RADAR". Do not
use the unit until the alert is resolved and the [Antenna] button shows the current an-
tenna selection (example: ANT-1(M)).
1. INITIAL SETTING AND ADJUSTMENT
Save and Sync Save and Sync System Monitor System Monitor Software Update Software Update
The result of the test is shown
in this area
Factory Test & Default Factory Test & Default
1-53