Table of Contents
Advertisement
1. INITIAL SETTING AND ADJUSTMENT
Tab name
Basic Setting
Own Ship Setting
Installation Parameters
CCRS
TCS
AMS
Alert Define List
Data Sharing*
Save and Sync
Radar Installation*
System Monitor
Software Update
Factory Test and
Default
Conning
*: Adjustment not required.
1.2
[Basic Setting] Menu
1.2.1
[Basic Setting] window
1. Access the [Common Installation Setting] menu and click [Basic Setting] on the
tab bar.
2. Click [Basic Setting] on the menu bar.
3. Select the Equipment ID of the processor unit from the [Equipment ID] pull-down
list. (Setting range: [CRA001] to [CRA004]. Do not select [CRA005] to [CRA010])
The [Equipment Name] and [IP Address] are automatically entered according to
the Equipment ID. For details, see the "EQUIPMENT ID List" at the back of this
manual.
Note 1: Assign a different Equipment ID to each processor unit.
1-4
Sets the Equipment ID, monitor, printer, and own ship infor-
mation etc.
Enters the ship's parameter and sensor position.
Sets the system configuration and input/output data.
Sets the priority of the sensors and NMEA sentences.
Sets the data format for the route data.
Sets the Alert Management System.
Sets the alerts.
Sets the interlocking system between units.
Save and synchronize the settings. You can save settings to
a medium.
Sets the radar installation parameters.
Confirms the system condition.
Updates the software.
Performs the factory test; restores the default settings.
Configures the layout and data to show on the conning dis-
play.
Feature
Advertisement
Table of Contents
