Alternate Trigger (Trigger Mode: Edge) - Owon XDS3204E User Manual

CH1
Source
CH2
Edge
Edge
Idle Time
Configure
Edge Num
Auto
Normal
Single
Mode
Holdoff
Holdoff
Reset

Alternate Trigger (Trigger mode: Edge)

Trigger signal comes from two vertical channels when alternate trigger is on. This
mode is used to observe two unrelated signals. Trigger mode is edge trigger.
Alternate trigger (Trigger Type: Edge) menu list:
Menu Settings
Alternate Mode Edge
CH1
Source
CH2
AC
Coupling
DC
Slope
Mode Auto
4.Advanced User Guidebook
Select CH1 as the trigger source.
Select CH2 as the trigger source.
Trigger on the rising edge of the input signal when
voltage level meets the specified trigger level.
Trigger on the falling edge of the input signal when
voltage level meets the specified trigger level.
Set idle time before the edge counting in Nth Edge
Trigger. Adjust M knob or click
press
move cursor to choose which digit to be set. Available
range is 30ns-10s, default 100ns.
Set the edge number value of "N" in Nth Edge trigger.
Acquire waveform even no trigger occurred
Acquire waveform when trigger occurred
When trigger occurs, acquire one waveform then stop
100 ns - 10 s, adjust M knob or click
interval before another trigger occur, press
panel button or click
which digit to be set.
Set Holdoff time as 100 ns
Instruction
Set vertical channel trigger type as edge trigger.
Channel 1 as trigger signal.
Channel 2 as trigger signal.
Block the direct current component.
Allow all component pass.
Trigger on rising edge
Trigger on falling edge
Acquire waveform even no trigger occurs
49
panel button or click
move cursor to choose
to set idle time
to
to set time