Owon XDS3204E User Manual page 82

Mode
Frame Set
End frame
Save
Load
To use wave record function, do as follows:
(1) Push Save button.
(2) Select Type in the bottom menu, in the left menu, turn the M knob to select
Record.
(3) Select Mode in the bottom menu, select OFF in the right menu.
(4) In the bottom menu, select Storage as Internal.
(5) Select Mode in the bottom menu, select Record in the right menu.
(6) Select FrameSet in the bottom menu, set End frame and Interval in the right
menu.
(7) In the bottom menu, set Refresh.
(8) In the bottom menu, select Operate as Play.
(9) Select Mode in the bottom menu, select Playback in the right menu. Set
FrameSet and Playmode, select Operate as Play.
(10) To save the wave recorded, select Mode in the bottom menu, select Storage in
the right menu. Select FrameSet in the bottom menu to set the range of frames to
store, select Save in the bottom menu.
(11) To load the waveform from the internal memory, select Load in the bottom menu,
then enter the Playback of the Mode to analyze the wave.
Note: When playbacking the waveform, the sampling, trigger, or display function is
not available.
When storage medium is External, Wave Record contains two modes: OFF,
Record.
Record menu (External Storage) shows as follows:
Menu Setting
Mode
Record
End frame
Record mode
FrameSet Interval
Infinity
Refresh
Operate
Note:
4.Advanced User Guidebook
to store (1 - 1000)
Turn the M knob to select the number of end frame to
store (1 - 1000)
Save the waveform record file to the internal memory
Load the waveform record file from the memory
OFF Close wave record function
Set record menu
Turn the M knob to select the number of frames to
record (1 – 900,000)
Turn the M knob to select the interval between
recorded frames (10ms - 10s)
Record infinitely until the storage medium is full
ON Refresh wave during recording
OFF Stop refreshing
Play Begin to record
Stop Stop recording
Instruction
75