Alternate Trigger (Trigger Mode: Edge) - Owon XDS3104A User Manual

Source
Edge
Idle Time
Configure
Edge Num
Normal
Single
Mode
Holdoff
Holdoff
Reset

Alternate Trigger (Trigger mode: Edge)

Trigger signal comes from two vertical channels when alternate trigger is on. This
mode is used to observe two unrelated signals. Trigger mode is edge trigger.
Alternate trigger (Trigger Type: Edge) menu list:
Menu
Alternate Mode
Source
Coupling
Slope
Mode
CH1 Select CH1 as the trigger source.
CH2 Select CH2 as the trigger source.
Edge Trigger on the rising edge of the input signal when
voltage level meets the specified trigger level.
Trigger on the falling edge of the input signal when
voltage level meets the specified trigger level.
Set idle time before the edge counting in Nth Edge
Trigger. Adjust M knob or click
press
move cursor to choose which digit to be set. Available
range is 30ns-10s, default 100ns.
Set the edge number value of "N" in Nth Edge trigger.
Auto Acquire waveform even no trigger occurred
Acquire waveform when trigger occurred
When trigger occurs, acquire one waveform then stop
100 ns - 10 s, adjust M knob or click
interval before another trigger occur, press
panel button or click
which digit to be set.
Set Holdoff time as 100 ns
Settings Instruction
Edge Set vertical channel trigger type as edge trigger.
CH1 Channel 1 as trigger signal.
CH2 Channel 2 as trigger signal.
AC Block the direct current component.
DC Allow all component pass.
Trigger on rising edge
Trigger on falling edge
Auto Acquire waveform even no trigger occurs
panel button or click
49
to set idle time
to
to set time
move cursor to choose